Common Problems: Egr Valve Dirt

Aerosol, formulated to eliminate residues and sediments in the intake circuit. Its powerful action removes and cleans varnish, oil, carbon and grease residues in: Carburetion or injection engines. Diesel or gasoline engines, both aspirated and turbos. Clean debris and sediment in intake manifolds, butterfly valves, turbochargers, oxygen sensors.

WHAT DOES?

Its powerful action removes and cleans varnish, oil, carbon and grease residues in:

- Carburetion or injection engines
- Diesel or gasoline engines, both aspirated and turbos

WHEN TO USE IT? - FOR:

- Clean debris and sediment in intake manifolds, butterfly valves, turbochargers, oxygen sensors
- Restore the correct acceleration and engine idling pattern
- Use on disassembled or disassembled parts such as charred or oil-filled EGR valves and lambda probes
- Clean the crankcase ventilation elements

HOW TO USE

1- Disassemble pipes and elements present up to the intake manifold / Butterfly valve
2- Start the engine, until reaching service temperature
3- Maintain the engine at a speed of 1,500 r.p.m. constant
4- At a distance between 20 and 30 cm, apply a short spray of 3 sec. and check that the engine does not accelerate in an uncontrolled 5- way or noises are produced by Pre-ignition (Engines with Turbo)
6- Once the normal behavior of the engine has been verified, start spraying for 5-10 seconds and alternate each one with 3 accelerations. Be attentive to engine response
7- Once the process is finished, let the engine run for 5-8 minutes to balance the mixture values
8- Turn off the engine and reassemble the necessary elements